1/2 Drill Bit.
Drywall
Cam Bracket
Codec Plate
Stud finder
Concrete Anchor
(4)
Quadrex Screw
(5)
Nut
(2)
Hex Bolt
(1)
Robertson
Bit #2
(1)
Hammer Drill
Philips or Robertson #2
Screwdriver or Drill
A
DETAIL A
Cable passage
for in-wall
Cable passage
Down Channel
Hammer
CS
Assembly and mounting Instructions
VIDEO FURNITURE INTERNATIONAL
165 McIntosh Drive Markham , Ontario L3R ON6 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: 1-905-946-8025 Local:905-946-1459
Note:
If you cannot understand these instructions or are concerned about the safety of the installation
Contact a qualified contractor or contact VFI at 1-877-834-3876.
Confirm all hardware is included before you begin assembly.
Not all hardware supplied will be used.
Thank you for purchasing VFI's Camera and Codec Shelf.
This product was designed for wall mounting of a
cam or codec onto a wood frame or masonry wall. The CS can also
be painted to match your wall colour if required.
Supplied Parts:
Supplied Hardware:
Tools required:
Page 1
of 2
Hardware
Bag
Masonry
Philips or Robertson #2
Screwdriver or Drill
Attaching Cam Bracket to wood studs in drywall
1) Using a stud finder, mark the stud center and draw a
line for leveling. Careful to avoid electrical wiring.
Holes can be pre-drilled with a 3/16 bit.
2)Using either a cordless drill or screw driver insert five
screws angled towards the center. Do not over tighten
Kommentare zu diesen Handbüchern